On plug-and-play systems, you can not install plug and play CPs manually (CP 5611 and CP 5511). The interface parameter set is then generated automatically. If the required interface parameter set is not displayed, you must first install a module or protocol via the "Select" button. In the list "Interface parameter set used", select the required interface parameter set. Set the "Access Point of Application" to "S7ONLINE." Procedure (Detail are found in the Online Help):ĭoubleclick on "Setting PG/PC Interface" in the "Control Panel" of Windows. In order to make it easier to assign parameters to the programming device/PC interface, a dialog box will display a selection list of default basic parameter sets (interface configurations).Īssigning Parameters to the PG/PC Interface In Windows 2000, Windows XP and Server 2003, the ISA component MPI-ISA card is no longer supported and therefore no longer offered for installation.
SIEMENS STEP 7 WINDOWS XP PC
If you are using a PC with an MPI card or communications processors (CP), you should check the interrupt and address assignments in the Windows "Control Panel" to ensure that there are no interrupt conflicts and no address areas overlap. To operate an interface, you will require the following:
This enables you to modify the interface parameters at a later time, independently of the installation. You can also open this dialog box after installation, by calling the program "Setting PG/PC Interface" in the STEP 7 program group. During installation, you are displayed a dialog for assigning parameters to the PG/PC interface. Here you configure the communication between the PG/PC and the PLC. Setting the PG/PC Interface Setting the PG/PC Interface
0 kommentar(er)
